Causes and solutions for heating of transmission drum

When using the transmission drum, the drum is often heated due to long use. Such a situation will cause equipment operation failure. What is the reason for this phenomenon? Now * let me give you a detailed introduction.
1. The worm gear is overheated, the bearing is damaged, foreign matters invade, and the worm gear and worm are excessively worn.
Solution: change or repair, change the bearing, remove foreign matters and change the smooth oil, change the worm gear of the transmission drum or the worm gear is excessively worn.
2. Overload transportation, too little or too much smooth oil, poor or inappropriate smooth oil, excessive friction of oil seal, improper connection between output shaft and transmission installation.
Solution: adjust * the appropriate load or select a large model, add the appropriate smooth oil according to the instructions, add the appropriate smooth oil after the oil is discharged, drop several drops of smooth oil on the oil seal, and adjust * the noise of the reducer at the appropriate position.
3. The transmission drum is poorly installed and fixed, the worm gear is worn or damaged, the bearing is worn or damaged, the bolt is loose, and foreign matters invade.
Solution: fix the transmission installation, change the worm gear, change the bearing, tighten the bolts, remove foreign matters and change the smooth oil leakage.
4. The worm gear and worm are poorly meshed, the bearing is damaged or the clearance is too large, there is a lack of smooth oil, and foreign matters invade.
Solution: trim the tooth contact surface, change the bearing, add excessive smooth oil according to the instructions, remove the foreign matters of the transmission drum and change the smooth oil for abnormal vibration.
5. The oil seal is damaged, the sealing gasket is damaged, the oil quantity is too much, the oil plug is loose, and the oil standard is damaged.
Solution: change the oil seal, change the sealing gasket, add excessive smooth oil, tighten the oil plug, change the oil, and mark the force or output shaft does not rotate.
The above five reasons are basically involved in the heating of the transmission drum. Therefore, when using the machine and equipment in daily life, we should pay attention to timely check whether the parts of the machine and equipment are normal, and solve the problems in time. We believe that finding the causes and timely handling can make the machine run more smoothly