Maintenance precautions for stripe brushes

The market is getting bigger and the demand is increasing. A few years ago, Domestic article brushing enterprises The development trend of the industry is obvious. Although there are many enterprises within the industry, due to low costs and fierce competition, many companies rely on low prices to win the market. Therefore, the profits of enterprises are very low, and they can only maintain production in a state that can only be achieved. However, it is difficult to make money, and the consequences are low prices, low added value, and low profits. Enterprises do not have enough funds for sustainable development. If enterprises cannot improve, the industry will not improve, which will lead to advantages and poverty. Enterprises do not have enough money Sufficient funds are needed to ensure that product design and technical content cannot be improved. Copying and accepting orders from overseas enterprises has become the ultimate choice for their survival. This will inevitably lead to a lack of domestic market in the high-end market. Brush Factory - Maintenance Precautions for Brush Bars
This brush is widely used in industries such as mechanical parts, plates, stones, process glass, electronic representation cleaning, polishing, polishing, rust, etc., and produces corresponding effects. Manufacturers of production and processing can perform special processing according to user requirements or machine dimensions, using steel wire, nylon yarn, pig hair, wool, tin, abrasives, etc.
Nylon is the most commonly used material in brush factories, and as usual, the nylon brush wires used in the brush industry can be divided into three categories: nylon 6, nylon 66, and nylon 612. In this case, nylon single 6 is a relatively economical material, double 6 has stronger hardness, and nylon 612 is higher. Nylon brush wire is a very important brush material, and the relevant characteristics of the brush are appropriate throughout the entire application process.
Brush Factory - Maintenance Precautions for Brush Bars
1. The surface of some joints should be smooth and clean. Before installing a new gasket, it is necessary to ensure that the surface of the joint components is clean of dirt. At the same time, it is also necessary to check for any surface warping, protrusions connecting screw holes, etc., and make necessary modifications. The sealing effect of the seal can only be achieved without warping.
2. The old sealing gasket cannot be reused. The engine should be installed between the surfaces of two components. After the gasket is compact, the surface roughness should be consistent with the sealing effect. Therefore, every time the engine is maintained, a new gasket should be replaced. Otherwise, the leak will be confirmed.
3. Before use, the engine gasket should be placed appropriately, and it should be completely placed in the original packaging without any delayed bending or overlap. The maintenance precautions for later maintenance should not be hung on the hook